By default, the order of processing is the order displayed
from left to right on the Spectron faceplate (the signal passes through the
Morph module, then the Filter, etc.). The spectrum meters are based on the final
output signal (after all processing).
Clicking on the "Graph"
button provides a signal path flowchart. The "Spectron Engine" is made up
of the Morph, Filter, Pan and Delay modules. You can choose to place these
spectral processing effects before or after the Smear module, and before or
after the spectrum meter. It's not possible, however, to change the ordering of
the modules within the Spectron Engine - i.e. the Morph, Filter, Pan and Delay
modules are contained within the Spectron Engine block and have fixed
positions.
To apply the new signal order, click on the OK button. If you want to reset to the default order, click the Reset button. Click the Cancel button to discard your changes.